Pipe Flange Specifications: Class and Pressure-Temperature Rating

한국어로 보기

What a pipe flange specification includes: ASME B16.5 classes, pressure-temperature ratings, how to choose a class, flange types, facings and bolting.

A pipe flange joins pipe, valves and equipment with bolts and a gasket, so the joint can be taken apart. For steel flanges from NPS 1/2 to NPS 24, the governing standard in process plants is ASME B16.5. It sets the dimensions, the bolting and the pressure-temperature ratings for seven pressure classes: 150, 300, 400, 600, 900, 1500 and 2500. Larger sizes, NPS 26 and up, are covered by ASME B16.47.

What a flange specification includes

A class is not a pressure

The class number is a name, not an allowable pressure in psi or bar. The pressure a flange may carry is its pressure-temperature rating: the maximum allowable working gauge pressure at a given temperature. The rating depends on the material group and falls as the temperature rises, because the strength of steel falls with temperature. The same Class 300 flange therefore allows a lower pressure at 400 °C than at ambient temperature, and a different material group gives a different rating at the same temperature.

How to choose a class

  1. Find the material group of the flange material specification in the standard’s material table.
  2. Take the design pressure and design temperature of the line.
  3. For each class, read the rating at the design temperature. Between two printed temperatures, interpolate linearly — the standard permits this.
  4. Choose the lowest class whose rating is equal to or above the design pressure.
  5. Check the notes for temperature limits on that material; a class cannot be used above the temperature the standard allows for the material.
  6. Confirm the result against the project piping class, which may set a higher class for other reasons.

The ratings apply to the flange alone. The hydrostatic shell test of a flanged fitting is done at no less than 1.5 times its 38 °C rating.

Flange types

TypeHow it joins the pipeTypical use
Welding neckButt weld to the pipeHigh pressure, high or cycling temperature; the tapered hub spreads the load
Slip-onPipe slides in; fillet welds inside and outsideLower pressure where easy alignment matters
Socket weldPipe sits in a socket; one fillet weldSmall bore lines
ThreadedPipe threadSmall sizes where welding is not wanted
Lap jointLoose ring over a stub endLines taken apart often; alloy pipe with a carbon steel ring
BlindNot joined to pipeCloses the end of a line or a nozzle

Facings

Bolting and gaskets

The number and diameter of bolts are fixed by the size and class. Bolt length also depends on the facing and the gasket. Gaskets are specified separately — metallic gaskets in ASME B16.20 and non-metallic flat gaskets in ASME B16.21.

Pick a material group, design pressure and temperature to see which class holds, with dimensions and bolting. Open the Flange Class calculator

More guides

Results are for reference and preliminary checks; a qualified engineer must verify them before use. Read the disclaimer